200 Toyota Tundra Rear Axle Bearing Removal

I greased up the bearing axle and seal surfaces placed the axle on the cement floor slid the backing plate over the axle then slipped that old bearing retainer onto the axle to protect the bearing inner race from the beating I was going to give the pipe.

200 toyota tundra rear axle bearing removal. I used snap ring pliers and a screwdriver. Bolts to the bearing flange and fits into a Harbor Freight or similar 20-ton hydraulic press. Remove the snapring.

Luckily an 1-12 schedule 40 steel pipe fit perfectly over the axle. Also it will fit any symmetrical 4-bolt. 3Disconnect the top shoe return spring big green one 4Disconnect bottom shoe return spring small one 5Remove the hold down spring cups.

After the axle is removed disconnect the service tool. Lubricate the new rear wheel bearing with the specified lubricant. The bearings should be able to move smoothly without any hang up if you are going to shift smoothly.

-put drain pan under axle housing-remove rear axle housing cover 10 or 12 bolts-turn gear untiil the bolt for cross shaft shows and remov e the bolt-remove the cross shaft-push axle in until you can remove U clip from axle and axle will pull out Remove seal you need a pulller to remove axle brg. Using the special tools remove the rear wheel bearing and wheel bearing oil seal. Genuine Toyota Part - 424600C011 42460-0C011.

The bearings last a long time but at some point you may need to replace this bearing on you. Our Toyota technicians have Access to all the OEM parts and follow factory. I read a few different stories of people replacing everything - seals.

Remove the axle shaft from the backing plate. 44 out of 5 stars. 08 PreRunner Regular Cab 98 4x4 Extra Cab.