2000 Toyota Tundra Ignition Switch Problems

There are several contacts in that switch that send power to all the systems in the truck according to the key position these do get corroded and worn over time.

2000 toyota tundra ignition switch problems. The most recently reported issues are listed below. What is the procedure to reset a radio in a 2000 tundra. Make sure both the lock cylinder and column lock are in the ACC position.

Start the car and get it to where it wont shut off like you describe then take a screwdriver and lightly smack each relay a few times with the handle see if anything happens. Inside the ignition switch several contacts connect vital electrical systems needed to start and run the car. Is your steering wheel locked.

The battery went dead on my 2000 tundra. 2002 Toyota Tundra problems. The engine will just turn over with no spark.

In the ACC position the radio or fan may be energized. 2001 Toyota Tundra problems. If your steering wheel is not locked and your key wont turn then do not touch the steering wheel your problem is 2 3 or 4 below.

While it would seem like the most likely cause for a key to get stuck in the ignition at first compared to it being a bad key this is not nearly as likely. Align the locking cam with the hole in the ignition switch and insert the switch into the lock housing. Of the time its.

Draw that circuit in GREEN from the battery to ground. Also please check out the statistics and reliability analysis of Toyota Tundra based on all problems reported for the Tundra. This is the lock pin.