2000 Toyota Tundra Rear Bumper Removal

All the same-as-original bumpers from Replace are a perfect option to go if you want to restore and maintain the original look of your vehicle.

2000 toyota tundra rear bumper removal. 2000 Toyota Tundra 1099. -remove the cover of the bumper underneath and Unscrew two screws on each side twisted upside down-around the bottom part Unscrew the screws spun up-assistant exempt corners of the latches in the wings and remove the bumper from the guides themselves-remove the connector from the fog lamp if any-remove connector from the PDC if any. Remove lights from two connectors 28.

Next underneath the bumper there are 2 clips that you need to pull out with a flat head screw driver they point straight to the ground and are holding the bumper extenders in place Then the easy part remove the 14mm bolts 2 on each side attached to the frame. Does anyone have a link to a thread with instructions on how to remove the front and rear bumper. Discussion Starter 1 May 16 2010.

Pull the bumper away from the vehicle and set aside. There is a screw on each side of the bumper cover at the wheel wells. Unplug and remove the Trailer Plug.

There are 3 plastic bumper covers. Get the longest flat tip screw driver that you can and crawl underneath the truck and try to pop those little tabs out from the plastic bumper covers. Remove black clips under tail lamps flat head screwdriver to pull center of.

The bumper is secured using four 13mm nuts. The forward two are in an open slot so just loosen them the bumper will tilt down and you can slide it slightly forward to remove. If you wish to remove the entire set up from the frame remove the bolts attaching the brackets to the frame rails.

Remove your license plate. Remove tail lamp four 8mm nut perside unplug wires. A Open the bonnet and look for one 13mm nut on the lower inside of each headlight.