2001 Toyota Tundra Drive Cycle

If your smog technician tells you the specific drive cycle to perform you can focus on just triggering that drive cycle.

2001 toyota tundra drive cycle. Otherwise you need to exercise each of the types of monitors. The average cost for a Toyota Tundra OBDII drive cycle test is between 44 and 56. How To Complete a 2001 Toyota Tundra Drive Cycle Engine Class 5VZ-FE 2UZ-FE Begin by.

Stop the vehicle and idle the engine for 3-5 minutes. It is very important to make sure your Toyota Tundra has only between 14 and 34 of fuel in the gas tank. The blower motor is located directly below the passanger glove box on the right.

It is a function of the repair shop to know if a drive. Return to idle for three minutes. If youve done the cycle with OD on try it with OD off.

Once a monitor has been set to ready it will continue to indicate ready unless the vehicles battery is. Stop the vehicle and idle the engine for 3-5 minutes. The following Drive Cycle should set all the required emission monitors.

A drive cycle is one of the methods used by a vehicles powertrain control module pcm to determine whether an emissions system repair was performed successfully. Repeat steps 1-3 once. Make sure the gas tank is nearly but not completely full around 34.

Do not exceed 30 TPS. The EVAP Monitor is not required to be complete Ready in order to pass the California smog check. Do not exceed 30 TPS.