2001 Toyota Tundra Grease Fittings

There are eight total zerks grease fittings and the grease to use is also listed on the diagram.

2001 toyota tundra grease fittings. For 1999-2004 Toyota Tacoma Intermediate Pipe Walker 69748GS 2002. Grease Fitting in Cross. Toyota should have grease fittings on the ball joints when.

One at the rear of the drive shaft - one in the middle and one at the front all on the rear shaft not the shaft going forward on 4x4s. The Toyota Owners Manual and the Factory Service Manual both recommend an NLGI-2 moly grease for the double-cardan joints and an NLGI-2 lithium-based grease for the u-joints and slip yokes. You dont want to force in so much that a gob of grease comes out.

2005 D-Cab OR 4x4. Pump it in slowly and youll probably hear it being forced out before you see it. How to Grease Joints with no grease fittingsIf you need to grease a ball joint or tie-rod end and it has no grease fitting there is a way to grease the no.

Camburg UCA Bushing and Sleeve Rebuild Kit. Toyota Oil Drain Plug Crushable Steel Gaskets Set of 10 OEM 12157-10010. 14 Feb 22 2017.

Your Toyota Owners Manual or Factory Service Manual specifies the proper type of grease to use on each part - either a moly or lithium base. Grease is cheap and you dont even need to lift your truck to do it. This matches my 2006 and probably all other years.

Most newer toyotas dont install grease fitting on there trucks when you replace a part you make sure you ask for greaseable. Theres a little debris shield to the driver side of it. Crawl under your truck to see if you have any in the front suspension and or driveline.