2003 Toyota Tundra Oil Pressure Sensor Location
Sunluway for ToyotaLexus Crankshaft Damper Pulley Holding Holder Harmonic Tool with Crank Bolts.
2003 toyota tundra oil pressure sensor location. Hey guys i gotta 2003 4x4 tundra with the 47 all stock. TanWhite oil pressure signal. The engine oil pressure sensor is on the left rear side of the engine block.
I think it is supposed to be around the oil filter but I cannot see it with the naked eye. 2 Feb 18 2009. Sent from my iPhone using Tapatalk.
Youll see the sending wire attached to it. Remove first the intake manifold sight shield cover. The 3 wires all go to the powertrain control module PCM.
This is a fix for a red oil pressure light on y. To the original poster you have an I-4 engine not a V-4. Ive had it for about 3 years.
And a bigger diameter then my 1 socket. If I recall its right on the filter attachment housing. The oil pressure switch has a one wire connector.
Assuming you have made sure your oil level is full I would replace the oil pressure sending unit. Just exercise just what we allow below as well as review toyota engine oil pressure sending switch drawing what you in the same way as to read. Its always had low oil pressure in my opinion at idle.