2006 Toyota Tundra Reset Low Tire Pressure Light

Push and hold the reset switch until the low tire pressure warning light blinks three times.

2006 toyota tundra reset low tire pressure light. This video will show you step by step how to reset the tire pressure warning light on several models of Toyota vehiclesHow to Reset Tire Pressure Warning Li. Apply the parking brake and turn the ignition to ON position with the engine OFF not the ACC position. With the car running or the Key On hold down the button til the yellow light begins to flash.

The light should go off a few minutes after the tire pressure is adjusted. 12 Under the right side cigarette lighter there is a 10mm bolt. Tire pressure reset process cannot be done while the vehicle is moving.

Several days later I was at the local dealer for an oil change and mentioned the light they adjusted the air pressure in all tires and did something to reset the warning light. Many Toyota Tundra models are outfitted with a tire-pressure-monitoring system that displays a low-tire-pressure warning on the control panel if it detects one of the tires is low. Hold down pressure warning reset switch located under the steering wheel or in glove box insert image of the reset switch until the TPMS telltale light blinks three 3 times.

Adjust the cold tire pressure in all four tires recommended on the tire placard. The system should only be reset when all of the tires. There are two ways to reset the indicator light - the first is to hold down the button hidden under the dashboard next to the steering column until the light goes out.

If the warning light blinks the tire pressure warning system may be malfunctioning. When the tire is filled or if the tires are changed or rotated the tire-pressure sensors must be reset to turn off the warning light and reinitialize the system. That it is the full procedure how to reset low tire pressure warning.

Tire pressure reset process cannot be done while the vehicle is moving. Adjust the cold tire pressure in all four tires recommended on the tire placard. Start the car and wait 20 minutes for the sensor to refresh.