P0393 Toyota Tundra

The camshaft position sensor senses the retraction of camshaft intake to identify a.

P0393 toyota tundra. Most auto repair shops charge between 75 and 150 per hour. If your engine has only one CMP such as an inline-four-cylinder the only CMP code available is for Bank 1 P0343. The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning.

The auto repairs diagnosis time and labor rates vary by location vehicles make and model and even your engine type. Full Forum Listing Explore Our Forums 2Gen-Tundra 1Gen-Tundra 1Gen-Sequoia Audio Stereo Engine Intake Exhaust Induction. 2010 crewmax 57 4x2.

Occur in the air gaps between the teeth and MRE which affects the magnetic field. Got the same result putting the new sensor at each location. The optical sensor provides a high resolution signal to the Powertrain Control Module PCM by counting pulses on the sensor disk located in the injection pump.

If the ECU detects high resistance it will set DTC P0343 or DTC P0348 Camshaft Position Sensor High Input. Information in questions answers and other posts on this site Posts comes from individual. Misfire Detected Cylinder 3 P0303 should not be ignored and can be a threat to the drivability the Toyota Tundra.

On the other hand V6 or V8 engines have two banks Bank 1 and Bank 2 and would therefore have two CMPs so DTC P0348. In most cases this code is almost identical to a P0345 code and the two may. Im reading that there are multiple sensors.

Engine runs fine maybe minor missing. This information is used by the Engine Control Module ECM to control ignition and fuel injection. Discussion Starter 13 Apr 8 2017.