Toyota Tundra Blower Motor Not Working

As the relay is the switch that supplies current to the blower motor if it fails internally then power will be cut off.

Toyota tundra blower motor not working. First time this happened the ac compressor would engage and disengage but still no air from the blower. Blower stopped working last Thursday It came back on Friday after I wiggled the blower motor resistor went back out Saturday. While there are a variety of reasons your Toyota Tundra heater is not working the most common 3 are a broken heater blower motor a problem with the thermostat or a failed heater blower motor resistor.

Bad blower switch 2008 toyota tundra put switch on hi goes to low speed does it have a resistor and were is it - Toyota Cars Trucks question SOURCE. Blower motor does not function One of the first symptoms of a problem with the blower motor relay is a blower motor that does not function at all. Also when the AC is on you can check under the hood and see of the compressor is kicking on.

Is this a bad switch not letting power to the relay. As long as the AC control assembly is working and the ground shown in the second drawing is good then yes the blower should run regardless of the resistor. Then after about 2 hours the blower started working again barely and over the next 10-15 minutes it gradually started working as normal and cooled as normal.

Ad Find Instant Quality Info Now. As soon as I adjust the knob to a higher or lower setting it. It may be the blower motor.

If it cranks right up. Discussion Starter 14 Apr 4 2017. I replaced the blower reaistor the blower motor and the relay.

The part number is listed above. HVAC Blower Motor Switch - Repair or Replace If Air PANEL AUTO DUCT - OEM Toyota Part 5590202070 55902-02070 Toggle navigation. Asked by Visitor in Vacaville CA on June 04 2021.