2000 Toyota Tundra Bolt And Washers

Be very careful not to damage core.

2000 toyota tundra bolt and washers. Attach the Sidebar to the Mounting Brackets with the included 6 8mm x 30mm Hex Bolts 6 8mm Lock Washers and 6 8mm Flat Washers Figures 3 - 5. I removed the front three bolts with ease but then went to take off the two rear bolts on the skid plate and realized they were stripped. Lower shroud assembly between engine and radiator and loosely mount at top using OEM bolts to original shroud mounting points.

A strut compressor is going to be needed to perform this installation. Thrust Washers- Toyota 4Runner Pickup Truck T100 Tacoma Tundra V6 30L 3VZ-E 34L 5VZ 1988-2004 OEM Thrust Washer Set 11011-62010 6505 Add To Cart Add to Compare. Remove the four lower ball joint bolts.

Have any of you done the same and never replaced it and had any. 9 90430-12031 TOYOTA Genuine Oil Drain Plug Gaskets QTY10 - 90430-12031. Carefully place the DriverLeft Sidebar onto the 3 Brackets.

Line up the horizontal top slot in the Bracket with the Hex Bolt Figure 6. Limited access cab with 47L 2wd. I just created a 1 body lift kit and heavily researched Gen1 Tundra bolt sizes.

They want you to fish the bolt and washer through the frame and the mount at the same time not going to happen with only 2 hands so i went to ace hardware and got some neoprene washers to slide over the bolts to hold them in the frame holes then gently slid the. The bed bolts were not that difficult to source once I knew what I needed. This is the washer that all new Toyotas and Lexus vehicles are supposed to have from the factory.

Wheelers Leaf Spring U-Bolts for Tacoma Tundra and Other Applications. When it comes to your Toyota Tundra you want parts and products from only trusted brands. Order Online or Call 866-596-1970.