2010 Toyota Tundra Maintenance Light Reset

Dont Start The Engine.

2010 toyota tundra maintenance light reset. Turn the Vehicle Back on. This video shows you how to reset the Maintenance Light on a 2010 Toyota Tundra. This Video shows you how to reset the Maintenance Light on a 2010 Toyota Tundra.

Go down and select the VEHICLE SETTINGS Use the arrows youre gonna be using up and down to scroll through the menu and then press the center button as the enter button Select MAINTENANCE RESET Press the center button to select Select YES When a confirmation message appears select YES to accepting the maintenance reset. The odometer should read Trip A. STEP 4 Press And Hold ODOTRIP BUTTON And Turn Ignition To RUN Position.

This occurs 4500 miles after the last reset. Determine that the odometer reading is displayed. Turn the ignition off.

At 5000 miles after reset it will come on and stay on. Put your key in the ignition and turn it to the on position Make sure that the trip or odometer is on the regular odometer ODO There we go now turn the ignition off Hold down the odometer button and turn the truck to the on position Keep hold the button then youll see the four flashing dashes and the maintenance required light will go away. Release the Trip button until the trip meter is set to all zeros.

Turn the ignition to run one position before starting engine. Press and hold the trip odometer knob. STEP 1 Turn The Ignition ON.

Step 2 Turn your key to the Off notch. Put the ignition key into the slot and turn on the car without kicking off the engine. Step 1 Turn your key to the On notch and press your trip odometer knob until Trip A is displayed.